If either of these symbols is displayed, refer to the instruction manual for the SCSI board and make the SCSI board settings again. Windows 2000 Professional Click Start - Settings - Control Panel - System - Hardware - Device Manager, and make sure that no “x” or “!” symbol appears next to the SCSI Controller entry. If the system dose not recognize the SCSI board properly, refer to the instruction manual for the SCSI board and make the SCSI board settings again. Windows NT 4.0 Workstation Click Start - Settings - Control Panel - SCSI Adapter, and make sure that the system recognizes the SCSI board properly. Windows 98/Me Click Start - Settings - Control Panel - System - Device Manager, and make sure that no “x” or “!” symbol appears next to the SCSI Controller entry. Also check the following, depending on which operating system you are using: Refer to the instruction manual for the SCSI board and correctly install the SCSI board in the PC correctly. The SCSI board is not correctly installed in the PC.
Check each possible cause.Ĭheck all the SCSI cable connections between the scanner, the SCSI board in the PC, and any other SCSI devices connected to the system. The following are possible causes of the PC failing to recognize the scanner.
0 kommentar(er)
